Versatile 20-slot ISA/PCI backplanes are available for the SP-2000 to hold two independent PC systems in a single chassis. The SP-2000's front control panel can support the CPU reset buttons and four DIN-5P keyboard ports for each individual system in the unit.

The SP-2000 comes with a 300-watt hot-swappable redundant power supply which increases the system's reliability and extends the system's life time.

Zero Down Time

This power supply unit is composed of two 300-watt independent power modules which share the system's load during normal operation. If one fails, the other will take the full load automatically without disturbing the system's operation. An audible alarm and visible LED will alert the user of system malfunctions.

Easy Maintenance

Maintaining the hot-swappable power supply is simple. Just unplug the bad power module and plug in a good one, all without turning off the main power during replacement.

The SP-2000's fault-detection system will continuously monitor the computer for power failure, fan failure and/or high temperature. Fault conditions are as follows:

• Power failure: If any power modules fail
• Fan failure: If any of the four cooling fans fail
• Excess temp: If the chassis internal temperature exceeds 65° C (149° F)

When a fault is detected, an audible alarm will sound to alert the user. The corresponding LED indicator (located on the front panel) will change color from green to red.

• 19" rackmount, 6U height, 18" depth
• Four high speed cooling fans for ventilation
• Reliable operation in 50° C (120° F) environment
• Vibration-dampened, front-accessible disk drive bay
• Positive air pressure in the chassis to keep out dust and dirt
• Rubber-buffered card hold-down clamp protects plug-in cards from vibration
• Lockable door for data security
• CE compliant and UL certified

• Construction: Heavy-duty steel chassis
• Disk drive: Supports four front-accessible, half-height drives. Vibration-damped with mounting holes for an extra two 3.5" HDDs inside
• Cooling fans: Four 49 CFM, front-mounted cooling fans (flow-in) with air filters
• Controls: Power On/Off switch, CPU reset button and alarm reset button. Protected by a lockable door
• Status indicators: Eight LEDs for +5 V, +12 V, -5 V, -12 V, HDD activity, power failure, fan failure and excess temperature
• Keyboard connector: Pre-wired 5-pin DIN connectors on both front and rear panels
• Speaker: One 8-ohm speaker
• Dimensions (W x H x D): 482 x 267 x 457 mm (19" x 10.5" x 18")
  
• Weight: 30 kg (66 lbs)
• Paint color: PANTONE 415C

• Power failure: If either power module fails, an LED alarm indicator will change color from green to red
• Fan failure: If any of the four cooling fans fail, an alarm indicator LED will change color from green to red
• Excess temperature: If the interior temperature exceeds 65° C (149° F), the LED alarm indicator changes color from green to red. It remains red until the temperature falls below 60° C
• Audible alarm: An alarm sounds to indicate malfunction. It remains on until the reset button is pressed. However, the LED light will remain red until the problem is resolved

• Output rating: 300 W (max.)
• Input voltage: 90 ~ 132 VAC or 180 ~ 264 VAC @ 47 ~ 63 Hz, switchable
• Audible alarm: +5 V @ 30 A, +12 V @ 12 A, -5 V @ 0.5 A, -12 V @ 0.5 A (min. load +5 V @ 3 A, +12 @ 1 A is needed)
• Safety: UL/CSA/TÜV approved
• MTBF: 100,000 hrs @ 70% load

• Slots: 20-slot, ISA/PCI-bus for full-size cards
• Segments: Two, 10-10
• PC board: 4-layer PCB with ground and power planes for reduced noise and lower impedance
• Indicators: LEDs for +5 V, -5 V, +12 V and -12 V

• Operating temperature: 0 ~ 50° C (32 ~ 122° F)
• Relative humidity: 10 ~ 95% @ 40° C, non-condensing
• Vibration (operation): 5 ~ 17 Hz, 0.1" double amplitude displacement; 17 ~ 500 Hz, 1.5 G acceleration
• Shock (operation): 10 G acceleration peak (11 msec. duration)
• Safety: UL approved
• EMI: Meets FCC/VDE Class A
• CE compliant

TOP